Brass Concrete Anchor And Insert Screw For Pool Covers

$3.75$96.00

Clear
SKU: H01932A Category: Tag:

Customers also viewed

Description

Brass Concrete Anchor And Insert Screw For Pool Covers

Replacement Brass Concrete Anchor And Insert Screw For Pool Covers. Solid brass screw-type anchors fit in the pool’s perimeter decking and are used to anchor the Safety Cover for the off-season.

Brass Concrete Anchor And Insert Screw For Pool Covers

Important Installation Information:

It is very important to determine and mark the exact location of anchor hole for Installation of Brass Concrete Anchor And Insert Screw For Pool Covers before installation procedure begins. Always refer to your safety cover installation manual for the proper use and placement of the anchors.
Installation

TOOLS REQUIRED FOR INSTALLATION
– Heavy Duty Rotary Hammer Drill
– ¾” Concrete drill bit with long shaft (carbide/diamond tipped)
– Tape measure
– Tamping Pin tool
– Hammer or rubber mallet
– Lubricant – Teflon or silicone spray
Anchor Hole Drilling

Once you have determined and marked the exact locations of Anchor hole, you can drill holes to accept the Anchor Shells. Make sure to keep the drill perpendicular to the deck surface. Measure the drill bit beveled depth. Then add the height of the anchor shell. Mark this measurement onto your drill bit with electrical tape or use drill guide. Drill the hole into the deck NO MORE THAN THE DEPTH of the Brass Anchor Shell taking care not to over-ream the diameter of the hole. If this does happen, simply apply some adhesive to the Brass Anchor Shell before setting it into the hole. Drilling dust can be removed with a vacuum cleaner or carefully blown out.

Due to the nature of poured concrete, some chipping is normal. This chipping can be reduced by using a sharp diamond tip drill bit and a high-speed rotary hammer drill. Also, our WS014 Brass Anchor Collars should be considered as an option for hiding chipped edges of the deck surface near the drilled hole and enhancing the beauty of your deck.

When your anchor hole is properly prepared, remove the Brass Anchor insert and the Brass Anchor. The shell can be lightly tamped into position by inserting the tamping tool into the Brass Anchor Shell and temp it into the deck with a hammer or mallet until it is flush with the deck surface. If you don’t have a tamping tool we recommend our WS017 anchor tamping pin tool.

A light Teflon or Silicone spray on the tamping tool prior to tamping will facilitate its easy removal after insertion of Brass Anchor Shell into the drilled hole. If the tamping tool should become jammed into the Brass Anchor Shell, try gently tapping the tool on the lateral sides to loosen it while pulling in an upward direction.

Note: To keep smooth operation it is recommended that anchor inserts be removed each fall and spring and shells cleaned out to remove any dirt or debris. The Brass Anchor Insert may also be lightly coated with a Silicone or Teflon spray to ensure smooth operation. DO NOT USE OIL OR GREASE!

Have Questions

If you have questions about the Brass Concrete Anchor And Insert Screw For Pool Covers, please feel free to give us a call at 1-800-515-1747 or send us an email, [email protected]

At Pool Warehouse, We Know Swimming Inground Pool Kits!

Additional information

Weight .18 lbs
Dimensions 3 × 1 × 1 in
Brand

Quantity

1 Anchors & Screws, 3 Anchors & Screws, 9 Anchors & Screws, 12' x 24' (23 Anchors & Screws), 14' x 28' (27 Anchors & Screws), 16' x 32' (29 Anchors & Screws), 18' x 36' (31 Anchors & Screws), 20' x 40' (35 Anchors & Screws)